Restore bed leveling and improve top surface

!IMPORTANT! Klipper users should double check if their config allows for a 230x225 bed. Otherwise you'll likely have a bad time

Changelog

• Add M420 S1 (restore bed leveling) to Marlin profile (#37) (#35)
• Improve top surface finish (#33) (#39)

Usage on print settings

There are 3 categories of print settings: slow, medium or fast. The faster you print, the less dimensionally accurate your print will be and the worse your print will look. For a good middle ground, pick medium

There are mutliple layer heights available to pick from: 0.1mm, 0.16mm, 0.2mm and 0.24mm. The smaller value you pick, the less layer lines will be visible, but the longer the print will take. For a good middle ground, pick 0.2mm

For most prints, the Normal 0.20mm profile will be sufficient

Install instructions

Automatic (Experimental)

1. Download PrusaSlicer_config_bundle.ini
2. Open PrusaSlicer, press File (in the top left) > Import > Import Config Bundle
3. Select the PrusaSlicer_config_bundle.ini that was downloaded in step 1

Manual

1. Make sure to have PrusaSlicer installed, opened at least once and followed the initial setup guide
2. Download the file Source code (zip)
3. Open up windows search and type in %APPDATA%, then press enter
4. Enter the PrusaSlicer folder in the newly opened explorer window
5. Open the Source Code .zip file, navigate into PrusaSlicer-Ender3-v3-SE-Config-1.2.2, then into PrusaSlicer
6. Copy everything in the .zip's PrusaSlicer folder to the PrusaSlicer folder in AppData
   • Replace files when asked

Donations

If you appreciate my work and would like to support me, consider buying me a coffee.
Your support is greatly appreciated!