Assembly

Compression Latches

Snapping the compression latches can be done with two bolts like shown in the video below:

Compression.Latch.Snapping.mov

Access Latch

The access latch has a space intended for one heat insert so that a bolt can be used to unclip it from the outside, to access the electronics inside.

Step-down converter

The flow chamber access latch is designed to snugly fit the Mateksys buck converter.

Sensor stack

Both BME and SGP sensors share the same I²C bus, so they can be soldered stacked onto each other. The full assembly in their holder should look like so:

Note: This is not they fit in StealthMax S version. Don't solder them onto each other if you are building a StealthMax S.

Soldering	Mounting onto holder

Lid