NAPALM Driver implementation for AOS-CX Switches.
All AOS-CX devices are supported, however the AOS-CX switch firmware should be version 10.05 or later, as some modules may have not been properly tested in older versions.
* get_arp_table - Get the ARP table from a device.
* get_config - Get configuration from the device.
* get_facts - Get the version, serial number, vendor, model, and uptime from a device.
* get_interfaces - Get list of interfaces from a device.
* get_interfaces_ip - Get list of interface IP addresses from a device.
* get_lldp_neighbors - Get the list of LLDP Neighbors from a device.
* get_lldp_neighbors_detail - Get LLDP Neighbor details from a device.
* get_mac_address_table - Get the MAC Address table from a device.
* get_ntp_servers - Gets NTP information from a network device.
* get_route_to - Shows an IP route on a device.
* get_snmp_information - Get the SNMP information of a device.
* is_alive - Check to see if the connection to the device is up.
* ping - Execute a ping command from the device.
Early versions of this driver will focus on the Get functions. Configuration handling is in current development.
For more information and guides to help get started, check out the Aruba Developer Hub section for NAPALM.
The following software is required:
- Python3
- Pip
- Python modules specified in
requirements.txt- pyaoscx
- requests
- urllib3
To install simply run:
pip3 install napalm-aruba-cx
The AOS-CX driver utilizes the REST API on the switches. Depending on the switch model, this may already be enabled. If not, please use the CLI commands below to enable REST on the specified VRF.
- There must be a user on the switch who belongs to the "administrators group" and has a password set. This user would then be allowed to access the REST API. In the below example, replace the username "admin" and password "mypassword" with your own username and password respectively.
8320(config)# user admin group administrators password plaintext mypassword
- Set the access mode for the HTTPS server to "read-write" and enable the HTTPS server on the VRF through which the client making the NAPALM calls can reach the switch. In the below example, this specifies both the management VRF and the default VRF.
8320(config)# https-server rest access-mode read-write
8320(config)# https-server vrf default
8320(config)# https-server vrf mgmt
Please read CONTRIBUTING for details on our process for submitting issues and requests.
This project is licensed under the Apache License - see the LICENSE file for details