Board and comands

[FrancoDouglas]

Hello
1st congratulations for the project. I can see it will work very well for everything that I plan.
I have some questions about how to wire a servo motor to the board. I read a lot of articles but I not security in which pins I should plug. Can you send a picture or a map of how to do it?
Another question is how to change, in case, inkscape, to work z axis with M03 and M05 comands.
Sorry if the questions are kind obvious but is realy hard for me to understand this! haha
Thanks

[robin-gdwl]

working on the same problems,
about the wiring:
connect the red wire to +5v on the arduino board
the brown wire to one of the GND pins
and the orange one to pin D11 on the arduino board

Ill let you know if I can find out how to configure inkscape