You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When I printed the rods out and tried to stack them, I noticed the connection point is not exactly flush or smooth at the connection point where the rods are stacked. I am currently having issues with finishing my printer because my sled gets caught at this section prohibiting me from printing tall prints.
I moved the rod into modeling software and stacked a copy of itself on top and noticed there is an overhang as shown in the images below. Is this an issue with the model? I know we have to re-generate the files using Open Scad, could this possibly be an issue that resulted from that?
The text was updated successfully, but these errors were encountered:
When I printed the rods out and tried to stack them, I noticed the connection point is not exactly flush or smooth at the connection point where the rods are stacked. I am currently having issues with finishing my printer because my sled gets caught at this section prohibiting me from printing tall prints.
I moved the rod into modeling software and stacked a copy of itself on top and noticed there is an overhang as shown in the images below. Is this an issue with the model? I know we have to re-generate the files using Open Scad, could this possibly be an issue that resulted from that?
The text was updated successfully, but these errors were encountered: