config_ADC.h

/*  
  OpenMQTTGateway  - ESP8266 or Arduino program for home automation 

   Act as a wifi or ethernet gateway between your 433mhz/infrared IR signal  and a MQTT broker 
   Send and receiving command by MQTT
 
   This files enables to set your parameter for the ADC value
  
    Copyright: (c)Florian ROBERT
  
    This file is part of OpenMQTTGateway.
    
    OpenMQTTGateway is free software: you can redistribute it and/or modify
    it under the terms of the GNU General Public License as published by
    the Free Software Foundation, either version 3 of the License, or
    (at your option) any later version.

    OpenMQTTGateway is distributed in the hope that it will be useful,
    but WITHOUT ANY WARRANTY; without even the implied warranty of
    MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
    GNU General Public License for more details.

    You should have received a copy of the GNU General Public License
    along with this program.  If not, see <http://www.gnu.org/licenses/>.
*/

/*----------------------------USER PARAMETERS-----------------------------*/
/*-------------DEFINE YOUR MQTT PARAMETERS BELOW----------------*/
#define ADCTOPIC  Base_Topic Gateway_Name "/ADCtoMQTT"
#define TimeBetweenReadingADC 500 // time between 2 ADC readings, minimum 200 to let the time of the ESP to keep the connection
#define ThresholdReadingADC 50  //  following the comparison between the previous value and the current one +- the threshold the value will be published or not

/*-------------------PIN DEFINITIONS----------------------*/
#define ADC_PIN A0 //on nodeMCU this is D3 GPIO0